Thursday, August 5, 2010












I found two pinholes in the backing metal so I put a heavy coat of POR-15 on and put a strip of fiberglass cloth in place. I then put another coat of POR-15 over that allowing it to completely wet out the cloth. When dry it is as strong as the tissue paper sheet metal the car is made of and it was easier than welding in little patches. I did fabricate a metal patch and welded it in. Didn't turn out too bad, couple low spots but that is what skim coats of body filler are for. I haven't metal prepped it yet, too hot out in the shop. I'll get it tomorrow.

No comments:

Post a Comment