Saturday, March 17, 2012

For once things went as planned. I got the car off of the rotisserie and supported on the lift. After removing the front supporting bracket I was able to work on the front end. What is shown in the picture was sanded and another coat of filler was added all the way across the seam. After sanding, it may be good enough to move on to the doors. If so, I'll have to put it back on the spit so I can move it to the other side of the shop.

Friday, March 16, 2012

Although I haven't posted recently, I have been working every day filling and sanding. You can probably tell that from the amount of dust on the floor. If all goes well I should be able to remove the car from the rotisserie and put it on the lift so I can work on the front end, again sanding and filling, filling and sanding. The fun part will be putting it back on the rotisserie to put another coat of epoxy primer on it, then sealer, filler primer to block it out, two coats of base and then three to four coats of clear. Some where in there I have to do the doors also.