Wednesday, February 24, 2010

The 30" of snow finally melted enough that I could lower the car, push it outside and turn it around and lift it up again to make it easier to work on the front panel. You can see the rotted out part under the battery box on the right side of the car. You can also see the tape marking the cut line I'm going to use. After cutting the bottom of the panel off, you can see that it was also rotted out on the inner panel. The good side of the removed part of the panel supplied a great patch panel, correct curve and all. I cut out the rotted part and fitted the patch but did not weld it in yet, that will probably be tomorrow depending on how much snow we get on tomorrows' storm. Might have to get out the snow blower again. The real test will be to see if I have enough guts to cut my NOS front panel in half to use to repair the above hole across the front of the car. If anyone reading this has a use for the top 2/3rds of the NOS front panel, it's up for sale, cheap.
did I mention it is an NOS panel? gggggg

No comments:

Post a Comment