Didn't get too much done today but I did get the patch metal prepped and I melted the brazing off of the rear fender lip so I could see what was under there .Not much better. I also rolled the whole rotisserie out of the shop and turned it around to make it easier to work on the drivers side front fender and rocker panel.
Friday, August 6, 2010
Didn't get too much done today but I did get the patch metal prepped and I melted the brazing off of the rear fender lip so I could see what was under there .Not much better. I also rolled the whole rotisserie out of the shop and turned it around to make it easier to work on the drivers side front fender and rocker panel.
Thursday, August 5, 2010
I found two pinholes in the backing metal so I put a heavy coat of POR-15 on and put a strip of fiberglass cloth in place. I then put another coat of POR-15 over that allowing it to completely wet out the cloth. When dry it is as strong as the tissue paper sheet metal the car is made of and it was easier than welding in little patches. I did fabricate a metal patch and welded it in. Didn't turn out too bad, couple low spots but that is what skim coats of body filler are for. I haven't metal prepped it yet, too hot out in the shop. I'll get it tomorrow.
Wednesday, August 4, 2010
Tuesday, July 27, 2010
Friday, July 23, 2010
Subscribe to:
Posts (Atom)