Thursday, August 5, 2010


While waiting for the paint to dry, I heated and scraped off about three pounds of undercoating from the wheel well. Also removed and cleaned up the rubber snubber from the spring mount.











I found two pinholes in the backing metal so I put a heavy coat of POR-15 on and put a strip of fiberglass cloth in place. I then put another coat of POR-15 over that allowing it to completely wet out the cloth. When dry it is as strong as the tissue paper sheet metal the car is made of and it was easier than welding in little patches. I did fabricate a metal patch and welded it in. Didn't turn out too bad, couple low spots but that is what skim coats of body filler are for. I haven't metal prepped it yet, too hot out in the shop. I'll get it tomorrow.

Wednesday, August 4, 2010












This is the area I'm going to make a patch for. After cutting out the corroded metal this is what I found. I chiseled off the blobs of bondo and vacuumed out the pile of dirt at the bottom to see what repairs are needed before the patch goes on.

Tuesday, July 27, 2010

After a lot of trimming, fitting, trimming some more I finally got the fender welded on. Again I removed the red primer, cleaned and metal prepped the surface to prevent rusting. I think I'm going to attempt to make a patch for the rear fender next. Wish me luck!

Friday, July 23, 2010










I got all the wheels sand blasted. They are all ready to send off to the paint shop. When they return, I'll mount the new tires on them and they will be all ready to go.

Tuesday, July 20, 2010











I got the rocker welded in today. Ground it smooth, stripped off the red primer, metal prepped it and quit. Had friends coming up from Baltimore and Florida to visit.

Saturday, July 17, 2010

The POR-15 is on but I haven't had a chance to weld anything yet, I've been working on a new roof. What else are supposed to do when it's in the high nineties??